Provide fresh air ventilation during first 2 to 3 burns. Never paint over an unprimed stainless-steel surface, or the finish will chip and peel soon after application. No other type of primer will promote adequate adhesion. Fresh paint may give off mild fumes and smoke the first few times it is heated. Stainless steel should never be painted unless it has first been abraded with a galvanized metal-etching primer. If you want to give your kitchen a new look, then you might be considering painting your stainless steel sink. They come in a variety of colors, shapes, sizes, and styles. DO NOT burn or place in home garbage compactor. Annie & Oak ApLianne Jones Can You Paint A Stainless Steel Sink Stainless steel sinks are beautiful, durable, and practical. Replace carefully, pointing can and spray head opening away from you.ĭispose of can in accordance with applicable regulations. If clogging occurs, remove spray head and clean with a fine wire. Clean spray head immediately after use by turning can upside down and spraying until no more paint appears. Apply two light coats, allowing 10 minutes drying time between coats. Hold can 12 to 15 inches from surface and apply using steady, even strokes. Shake can vigorously for one minute after mixing ball rattles freely to ensure proper mixing and to prevent spray head from clogging. For best results apply when spray can and room temperatures are between 60 and 80☏ (16 and 27☌). Protect adjacent areas with drop cloth or newspapers.

Remove all dust, dirt, rust, oil, grease and loose paint from surface. Do not apply unless surface temperature is between 60 and 90☏ (16 and 32☌). Make certain surfaces and contents of item to be painted have completely cooled down. Thurmalox High Temperature Stove Paints can be used for:Īpplication Directions Before applying, observe safety precautions. Also available in quarts, gallons and a variety of colors in 12 oz. Allow the paint to dry completely before using the stainless steel. It’s important to apply the paint in thin, even coats. Once the surface is clean, apply a thin layer of paint. You can do this by wiping it down with a damp cloth. Thurmalox Stove Paint withstands continuous temp's to 1200☏. Begin by cleaning the surface of the stainless steel. Fortunately, you did not suffer any damage since you did it at work, hopefully under controlled conditions.Thurmalox Stainless Steel High Temperature Paint Apply the second coat, and allow it to dry. Allow the first coat to dry for the amount of time directed by the manufacturer. Apply the first coat with the paint roller. It must always be used under controlled conditions. Use a 3/16 to nap roller, as is recommended for even application to smooth stainless-steel surfaces. I don’t like to recommend hydrofluoric acid etches because of the safety hazard.

Hydrofluoric acid etching is a pretreatment. Paint adhesion to stainless steel is enhanced by using pretreatments. Stainless steel is relatively inert, hence paint adhesion could be a problem. Yes, your finish procedure was right but perhaps a bit risky. Could I have eliminated the acid etch and just used the wash primer, or vice versa? B. That was coated with a gel coat epoxy primer. Then, after I had sanded and faired it out, I warmed it up and painted it with hydrofluoric acid to etch it, rinsed it and painted it with a wash primer. I built a SS rudder for a 40-ft sailboat after the second fiberglass one broke apart.

This is what I did and I am curious if you think it was right. I was interested in your solution for painting the stainless steel medicine cabinet, but I was hoping you would also include the “government job” solution done at work.

Stainless steel paint before and after